[Oct 19, 2024] New Cisco 350-601 Dumps with Test Engine and PDF (New Questions)
Pass Your 350-601 Exam Easily - Real 350-601 Practice Dump Updated
NEW QUESTION # 135
Refer to the exhibit.
In a bidirectional PIM network using Phantom RP as an RP redundancy mechanism, two Cisco NX-OS routers have these requirements:
* R1 must be the active RP.
* R2 must be the backup RP that is used only if R1 is not reachable
Drag and drop the configuration steps to complete the configuration for Router 2. Not all configuration steps are used.
Answer:
Explanation:
Explanation
10.10.32.121/29 ,
10.10.32.122,
point-to-point ,
sparse-mode
NEW QUESTION # 136
An engineer has a primary fabric that is named UCS-A and a secondary fabric that is named UCS-B. A certificate request that has a subject name of sjc2016 for a keyring that is named kr2016 needs to be created.
The cluster IP address is 10.68.68.68. Which command set creates this certificate request?
A)
B)
C)
D)
- A. Option A
- B. Option C
- C. Option D
- D. Option B
Answer: B
NEW QUESTION # 137
An engineer is implementing security on the Cisco MDS 9000 switch. Drag drop the descriptions from the left onto the correct security features on the right.
Answer:
Explanation:
NEW QUESTION # 138
An engineer is enabling port security on a Cisco MDS 9000 Series Switch. Which feature of enabling port security on a Cisco MDS 9000 Series Switch must be considered?
- A. It authorizes only the configured sWWN to participate in the fabric.
- B. It binds the fabric at the switch level.
- C. It always learns about switches that are logging in.
- D. It can be distributed by using Cisco Fabric services.
Answer: D
NEW QUESTION # 139 
Refer to the exhibit. The Cisco Nexus Series Switches SW1, SW2, and SW3 are connected via Layer 2 copper interfaces. An engineer implements loop prevention standard IEEE 802.1w on each VLAN lo provide lasier recovery from network changes or failures. The Implementation has these requirements
* Interfaces that are connected to Layer 2 hosts must not receive STP BPDUs.
* The implementation must detect unidirectional links due to one-way traffic twisted-pair links
* Bridge assurance must be enabled between SW2 and SW3
* The Layer 2 domain must be protected from superior BPDUs that arrive from external switches.
Drag and drop the code snippets from the right onto the blanks in the code on the left to complete the configuration for SW3. Not all code snippets are used.
Answer:
Explanation:
Explanation:
Network
Aggressive
Bpdu
edge
NEW QUESTION # 140
Refer to the exhibit. A pair of Cisco Nexus switches form a vPC. A new chassis s added to the pre-existing Cisco UCS domain. A new chassis must be discovered, and all links from the chassis to the LAN network must be established.
Which set of actions accomplishes these requirements?
- A. Option A
- B. Option C
- C. Option D
- D. Option B
Answer: B
NEW QUESTION # 141
Refer to the exhibit.
Which action must be taken before the maintenance policy can be committed?
- A. Set the policy to apply the change on the next reboot.
- B. Specify a maintenance time by selecting a schedule.
- C. Associate a service profile to the maintenance policy.
- D. Set the soft shutdown timer to a specific time.
Answer: B
NEW QUESTION # 142
A Cisco IMC on the Cisco UCS C-Series Server must be configured with VLAN ID 110 and a priority value of 20. Which command set meets these requirements?
- A. Server# scope cimc
Server /cimc # scope network
Server /cimc/network # switchport mode access
Server /cimc/network *# switchport access 110
Server /cimc/network *# spanning-tree portfast
Server /cimc/network *# copy run start - B. Server# scope cimc
Server /cimc # scope network
Server /cimc/network # switchport mode trunk
Server /cimc/network *# switchport trunk native vlan 110
Server /cimc/network *# spanning-tree portfast
Server /cimc/network *# copy run start - C. Server# scope cimc
Server /cimc # scope vlan
Server /cimc/network # enable vlan
Server /cimc/network *# set vlan-id 110
Server /cimc/network *# set vlan-priority 20
Server /cimc/network *# commit - D. Server# scope cimc
Server /cimc # scope network
Server /cimc/network # set vlan-enabled yes
Server /cimc/network *# set vlan-id 110
Server /cimc/network *# set vlan-priority 20
Server /cimc/network *# commit
Answer: D
NEW QUESTION # 143
Host 1 is in VLAN 100 located is DataCenter 1 and Host2 is in VLAN200 located in DataCenter2. Which OTV VLAN mapping configuration allows Layer 2 connectivity between these two hosts?
- A. Option B
- B. Option A
- C. Option C
- D. Option D
Answer: A
NEW QUESTION # 144
Refer to the exhibit. Two data center fabrics use VPC data center interconnect. The system MAC value on SW1 is 00:23:04:ee:be:20. Which value must be set to configure the system MAC address?
- A. 00:23:04:ee:be:14 on SW2
- B. 00:23:04:ee:be:20 on SW3
- C. 46:43:32:e5:92:80 on SW2
- D. 00:23:04:ee:be:14 on SW3
Answer: D
Explanation:
A is the only option that ensures the two vpc domains have different system MACs.
NEW QUESTION # 145
A POAP-enabled Cisco Nexus switch will not enter POAP mode. Which two conditions should be verified? (Choose two.)
- A. Bootflash must contain a special directory named POAP with poap.py file.
- B. No Cisco NX-OS image is present on the bootflash.
- C. The switch is in bootup process.
- D. The license file is missing on the switch.
- E. No startup configuration is available.
Answer: A,D
NEW QUESTION # 146
The Cisco Nexus 5600 Series Switch experiences occasional packet drops on interface ethernet 1/16. An engineer wants to implement a SPAN session to investigate the issue further. The network analyzer to which the packets must be directed is located on interface 1/3. The analyzer is limited on disk space available for traffic capture, so the Nexus switch should send only the relevant dat a. Which two command sets configure the SPAN session that meets these requirements? (Choose two.)
- A. Option E
- B. Option C
- C. Option D
- D. Option B
- E. Option A
Answer: A,E
Explanation:
https://www.cisco.com/c/en/us/products/collateral/switches/nexus-5000-series-switches/white-paper-c11-733022.html The information to be sent is regarding dropped packets only.
NEW QUESTION # 147
An engineer needs to monitor ingress traffic that arrives at interface Ethernet 1/3 that belongs to a Cisco Nexus 5600 Series Switch. The traffic analyzer machine located at interface Ethernet 1/5 is already monitoring other production, and the traffic analyzer must not be impacted by the traffic captured from the interface Eth1/3. The operations team allocated a traffic budget for the new monitoring session of 1 Gbps to meet this requirement Which set of commands configures the SPAN session?
- A.
- B.
- C.
- D.
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5600/sw/system_management/
7x/b_5600_System_Mgmt_Config_7x/b_6k_System_Mgmt_Config_7x_chapter_01110.html
NEW QUESTION # 148
Refer to the exhibit.
Which backup operation type does not include the Preserve Identities feature?
- A. full state
- B. logical configuration
- C. all configuration
- D. system configuration
Answer: B
Explanation:
The backup operation type that does not include the Preserve Identities feature is the logical configuration.
This type of backup includes the settings and configurations that are logically defined within the Cisco UCS Manager, such as service profiles, policies, and management settings. However, it does not include the unique identifiers or 'identities' such as MAC addresses, WWN pools, and UUIDs, which are preserved in other types of backups like system configuration and full state.
References: The information about different backup operation types and the specifics of what each includes can be found in the Cisco Data Center Core Technologies documentation and the Cisco UCS Manager Backup and Restore Management Guide1.
NEW QUESTION # 149
An engineer performs a set of configuration changes for the vPC domain using Session Manager. Which two commands are used to verify the configuration and apply the device changes when no errors are returned?
(Choose two)
- A. apply
- B. commit
- C. checkpoint
- D. verify
- E. write
Answer: A,B
Explanation:
Option C and E are the correct commands to verify the configuration and apply the device changes when no errors are returned using Session Manager. The verify command checks the syntax and validity of the configuration commands, and the apply command applies the configuration changes to the device. The other options are either not related to Session Manager or not required for the task. References:
* Cisco Nexus 9000 Series NX-OS System Management Configuration Guide, Release 9.3(x) - Configuring Session Manager [Cisco Nexus 9000 Series Switches], Configuring Session Manager, Using Session Manager
* Cisco Nexus 9000 Series NX-OS System Management Configuration Guide, Release 9.3(x) - Configuring Session Manager [Cisco Nexus 9000 Series Switches], Configuring Session Manager, Session Manager Commands
NEW QUESTION # 150
An engineer must start a software upgrade on a Cisco Nexus 5000 Series Switch during a zone merge. What is the result of this action?
- A. The zone merge executes and then the upgrade completes.
- B. The zone merge stops.
- C. The zone merge pauses until the upgrade completes
- D. The upgrade stops
Answer: D
Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5500/sw/upgrade/602_N2_2/n5500_upgrade_d
NEW QUESTION # 151
......
Cisco 350-601 exam is designed for network professionals who have a minimum of three to five years of experience in designing, deploying, and managing data center technologies. 350-601 exam validates the candidate's knowledge and skills in implementing data center technologies, including network virtualization, automation, storage networking, and security. Implementing Cisco Data Center Core Technologies (350-601 DCCOR) certification is recognized globally and is highly valued by employers in the IT industry.
Cisco 350-601 certification exam is an essential requirement for professionals looking to advance their careers in the data center industry. Implementing Cisco Data Center Core Technologies (350-601 DCCOR) certification demonstrates the candidate's skills and knowledge in implementing and managing complex data center solutions, making them highly valuable to organizations. Implementing Cisco Data Center Core Technologies (350-601 DCCOR) certification is recognized globally and is highly valued by employers, making it an excellent investment for professionals looking to grow their data center careers.
Exam4PDF just published the Cisco 350-601 exam dumps!: https://practicetorrent.exam4pdf.com/350-601-dumps-torrent.html
