A customer uses an out-of-band management network for discovery and direct management of their devices.
Which scope options should be selected to enablethis?

• A. The out-of-band network should be scoped through the Scope Properties dialog but should not be added to the Seed List (uncheck the Add to PingSeed List option).
• B. Both the in-band and out-of-band addresses should be scoped and seeded as usual.
• C. This cannot be scoped properly through the ScopeProperties dialog. Additional configuration is required in the DiscoScope scope.special configuration section.
• D. The in-band scope should be added as usual and the out-of-band addresses should be explicitly excluded.

A customer has created a new set of poll policiesthat are targeted against specific network views using adaptive polling. The filter conditions for these network views are broad and may contain a large number of devices for the poll policy to run against. Which two actions limit the impact this may haveon the other polling? (Choose two.)

• A. assign a policy throttle to the poll policy limiting the maximum number of targets
• B. reduce the scope of the Network View filter to limit the number of devices that will be in the view at any one time
• C. create a specific poller instance and assign the policy to thispoller ensuring that the impact on the existing polling is minimized
• D. assign a Maximum Node limit in the Network View Filter builder or in the template file
• E. change the status.map.maxnodes Topoviz status property to limit the number of devices within the networkviews

In the Advanced tab of the Discovery Configuration graphical user interface, what does the Enable Ping Verification option do?

• A. It ensures that subnets passed by the feedback mechanism are pinged before being sent to the Details agent.
• B. It checks theavailability of interfaces using Details.returns to ensure accurate polling.
• C. It ensures that seed file entries are available before being passed to the discovery.
• D. It checks the availability of the IP address used for chassis (EntityType 1).

A customer does not know the IP ranges in use in the network other than they all start with 10.0*. Which restriction is applied to wildcard scopes in the Scope Properties dialog?

• A. IPv4 wildcards are not permitted; only IPv6 subnets can be entered as a wildcard.
• B. A Class B equivalent wildcard is not permitted, wildcard scopes must be lowerthan a ClassB.
• C. A wildcard scope cannot be used in conjunction with the Add To Ping Seed List option.
• D. A wildcard scope can only be used in conjunction with the Exclude option.

When IBM Tivoli Network Manager IP Edition V3.9 (ITNM) isconfigured to a remote virtual ObjectServer pair, which ObjectServer entry list in omni.dat is necessary on the ITNM server?

• A. one for Primary, one for Backup, and one for VirtualObjectServer Pair
• B. one for Primary and one for Backup
• C. one for Primary, one for Backup, one for ITNM fail-over, and one for Virtual ObjectServer Pair
• D. one for Virtual ObjectServer Pair